Wykaz publikacji wybranego autora

Jerzy Zych, prof. dr hab. inż.

profesor zwyczajny

Wydział Odlewnictwa
WO-ktf, Katedra Tworzyw Formierskich, Technologii Formy i Odlewnictwa Metali Nieżelaznych

  • 2018

    [dyscyplina 1] dziedzina nauk inżynieryjno-technicznych / inżynieria materiałowa

[poprzednia klasyfikacja] obszar nauk technicznych / dziedzina nauk technicznych / metalurgia

Identyfikatory Autora Informacje o Autorze w systemach zewnętrznych

ORCID: 0000-0003-3067-4316 połącz konto z ORCID

ResearcherID: V-6164-2018

Scopus: 22982564300

PBN: 5e709208878c28a04738ee50

OPI Nauka Polska

System Informacyjny AGH (SkOs)

1
  • A new laser-registered view of the shrinkage kinetics of foundry alloys
2
  • Advancement of the hardening front in forms and cores made of quickly bonding composites – ultrasonic analyses
3
  • Analysis of modern methods of assessing the quality of sand foundry moulds
4
  • Behavior of chemically bonded molding sands in dry air
5
6
  • Copper alloys in investment casting technology
7
  • Diagnostic methods of technological properties and casting cores quality
8
  • Ecological water-based protective coatings for moulds and cores of iron castings
9
  • Effectiveness of protective action of coatings from moisture sorption into surface layer of sand moulds
10
  • Gas evolution rates of graphite protective coatings in dependence on the applied solvent and kind of atmosphere
11
  • Gases emission from surface layers of sand moulds and cores stored under the humid air conditions
12
  • Humidity migration in surface layers of sand moulds during processes of penetration and drying of protective coatings
13
  • Indicator $W_{so}$: a new parameter for characterization of protective coating efficiency against humidity
14
  • Influence of refining treatments on the properties of Al-Si alloys
15
  • Influence of structural discontinuities on fatigue life of 4XXX0-series aluminum alloys
16
17
  • Influence of the selected factors on thermal fatigue of the ADI in an aspect of its suitability as the material for metal moulds
18
  • Investigations concerning improvements of the knock out property of ceramic moulds applied in the investment casting technology
19
20
21
  • Kinetics of the binding process of furan moulding sands, under conditions of forced air flow, monitored by the ultrasonic technique
22
  • Monitoring the thixotropic effect in water-clay slurry systems used as a binder for moulding sands
23
  • Plasticity changes of moulding sands with chemical binders caused by increasing the hardening degree
24
  • Pulsating gas dosage in the moulding sands hardening process in the cold-box technology
25
  • Rheological properties of ceramic slurries with colloidal binders used in the investment casting technology