Wykaz publikacji wybranego autora

Sławomir Gruszczyński, prof. dr hab. inż.

profesor zwyczajny

Wydział Informatyki, Elektroniki i Telekomunikacji
WIEiT-ke, Instytut Elektroniki

  • 2023

    [dyscyplina 1] dziedzina nauk inżynieryjno-technicznych / automatyka, elektronika, elektrotechnika i technologie kosmiczne

  • 2018

    [dyscyplina 1] dziedzina nauk inżynieryjno-technicznych / automatyka, elektronika i elektrotechnika

[poprzednia klasyfikacja] obszar nauk technicznych / dziedzina nauk technicznych / elektronika

Identyfikatory Autora Informacje o Autorze w systemach zewnętrznych

ORCID: 0000-0002-0370-8640 połącz konto z ORCID

ResearcherID: brak

Scopus: 55925872500

PBN: 5e70922b878c28a047391137

OPI Nauka Polska

System Informacyjny AGH (SkOs)

Liczba pozycji spełniających powyższe kryteria selekcji: 257, z ogólnej liczby 264 publikacji Autora

1
  • 3D printed K-band air-filled waveguide directional coupler integrated with PCB using a through-patch transition
2
  • A 24 GHz microwave sensor with built-in calibration capability designed in MMIC technology
3
  • A broadband 3 dB tandem coupler utilizing right/left handed transmission line sections
4
5
  • A broadband low-cost antenna array for frequency modulated continuous wave (FMCW) radars operating at 24 GHz
6
  • A least-squares approach to the calibration of multiport reflectometers
7
8
  • Accurate broadband multiport reflectometer
9
  • Additively fabricated 90${^\circ}$ waveguide twist integrated with printed circuit board
10
  • An 85-GHz low-power low-noise amplifier with 15 GHz bandwidth in 22nm FD-SOI CMOS for 5G communications
11
12
  • Analog coherent detection in application to high-sensitivity nonlinear junction detectors
13
  • Analysis of TEM three-section symmetrical directional couplers with tandem-connected center section
14
  • Aperture-coupled microstrip antenna integrated with a PET-G dielectric lens
15
  • Application of 3 x 3 Butler matrix in wideband measurements of scattering parameters
16
  • Application of 3-D printing technology for the realization of high-performance directional couplers in suspended stripline technique
17
  • Application of additive manufacturing technologies for realization of multilayer microstrip directional filter
18
  • Application of aerosol jet 3-D printing with conductive and nonconductive inks for manufacturing mm-wave circuits
19
  • Application of 'C' section based left-handed transmission lines for coupling enhancement of coupled-line directional couplers
20
  • Application of computed microtomography for 3D imaging of LTCC structures
21
  • Application of computed microtomography for 3D imaging of LTCC structures
22
  • Application of RH and LH sections for reduction of coupling coefficients in two-section asymmetric directional couplers
23
  • Application of the 4 $\times$ 4 Butler matrix consisting of tapered-coupled-line directional couplers in an ultra-broadband multiport reflectometer
24
  • Approach to the design of asymmetric coupled-line directional couplers with the maximum achievable impedance-transformation ratio
25
  • Approach to the design of slot-coupled-line directional couplers